This happened to me about 3 years ago. It was a serious problem because
it will damage (greatly) the life of the laser. I think it was an issue
with the power supply - 3D replaced and it fixed it.
At any rate - I think you should get in contact with 3D immediately.
You too, Elaine ;)
Rapid Design Technologies
> My SLA 250 has a high power Omnichrome laser that starts up at
> times, runs for 3 or 4 minutes, then shuts down -- all without a
> command from the user. Anyone have a clue as to why?
> Rick Lott
> Hughes Space and Communications
> Los Angeles, Calif.
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:40:02 EEST