29 July 1997
Khaing Min Wai . . .
A 130 Meg file is big, but much will depend on the architecture of the platform you're running UG on.
Try simplifying the STL translation by cutting your UG part into small sections/geometries and exporting STL files of these smaller sections/geometries. If successful, concatenate/combine these smaller sections into one. Just make sure that you select a common reference point (ie. coordinate system) so that the sections will be in the correct 3-dimensional space w/ respect to each other.
Hope this helps,
Michael J. Doung
Plynetics Express Corporation
627 McCormick Street
San Leandro CA 94577
From: Khaing Min Wai[SMTP:email@example.com]
Sent: Tuesday, July 29, 1997 5:16 PM
Hello RP world,
My part file size is 130 MBytes on UG 11.0.0 and it is difficult to export
STL file and took too much time.I didn't succeed.
Is 130 M Bytes part file too big to creat STL file?
I put Triangulation tolerance 2.0mm and Adjancency Tolerance 1.0mm,
Only solid 2.5mm thickness (max.).
Help me !!
Khaing Min Wai
Mail box 1033
Asian Institute of Technology
Fax : 66-2-5245979 (Attn: KMW SV 19 A 2)
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:58 EEST