Re: Speed of Stereolithography Resins

From: M. Burns (marshall@ennex.com) ((marshall@ennex.com))
Date: Wed Jan 29 1997 - 06:20:52 EET


Dear Bronson,

     Thank you for the first RP-ML message I have seen in a long time
with serious technical content. The issues you raise point out the fact
that we cannot make simple comparisons between systems (or materials).
This is a problem we face repeatedly when people ask us which machine is
the fastest, or the most accurate, or ... The answer is usually that it
depends on what you are planning to make, and sometimes what you are
going to use it for.

Best regards,
Marshall Burns
marshall@ennex.com

*************************************************************************
** Ennex(TM) Fabrication Technologies **
** FABRICATING THE FUTURE (TM) **
******* *******
** 10911 Weyburn Avenue, Suite 332, Los Angeles, U.S.A. 90024 **
** Phone: +1 (310) 824-8700 Fax: +1 (310) 824-5185 **
** E-Mail: fabbers@ennex.com **
*************************************************************************



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:39:17 EEST