[rp-ml] Problem with SLA 250/50

Carl Dekker cdekker at metlflo.com
Mon Feb 19 15:53:19 EET 2018


Never had that error but based on what you have ruled out, I would guess it is hardware more than software.  Have you checked all external and internal fuses?  Can you swap out hardware or test them on another machine?  Good luck. Please share your solution.

Thank You,
Carl Dekker

'Your Rapid Manufacturing Partner'

Sent from mobile device.
(So please excuse any tpyos or omisions ;)


On Feb 19, 2018, at 12:57 AM, Solid Concepts <prototype at solid-concepts.com.au<mailto:prototype at solid-concepts.com.au>> wrote:

Good morning Rapid Prototyping Community,

I hope you are all well and that perhaps someone can help me solve a problem related to an SLA. I have an SLA 250/50 from 95.
The machine has been upgraded with a solid state laser and was working perfectly well until, during a built, it stopped with a
message saying that the door was open. Impossible to restart the machine, during the rebooting the same message shows up.
I have checked the cables and even closed the connection making a loop at the switch, all to no avail. The operating system is
DOS I have even tried another VAT controller but the same message comes up, "door is open, please shut door to continue"!

Can someone please help me resolve this problem? Do you have any suggestion as to what could cause this anomaly?

Thanking you in advance.

Kind regards

Francois Primon

Solid Concepts Pty Ltd
Unit 17, 64-66 Bannister Road
Canning Vale WA 6155

Tel: (08) 9455 5377

rp-ml mailing list
rp-ml at rp-ml.org<mailto:rp-ml at rp-ml.org>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rapid.rp-ml.org/pipermail/rp-ml/attachments/20180219/f5d8a293/attachment.html>

More information about the rp-ml mailing list