agreed but didn't know that thermally sintered was a criteria, Nikolaos
only asked about powder based application
Josh
On Wed, Oct 3, 2012 at 12:12 PM, David K. Leigh <dkleigh@harvest-tech.com>wrote:
> Does not appear to be thermally sintered - looks like low temp binder
> application like ZCorp.
>
> Sent from my iPhone
>
> On Oct 3, 2012, at 12:54 PM, "Joshua Harker" <info@joshharker.com> wrote:
>
> check this: http://pwdr.github.com/
>
>
> On Wed, Oct 3, 2012 at 3:38 AM, N. Kontolatis <nkontol@central.ntua.gr>wrote:
>
>> Has anyone tried to build a custom powder bed for layer manufacturing or
>> found a ready to implement solution on the market? Any information on the
>> matter or point to the right direction would be appreciated.
>>
>> Thank you in advance,
>>
>> Nikolaos G. Kontolatis
>> Researcher, PhD candidate
>> Manufacturing Technology Section
>> School of Mechanical Engineering
>> National Technical University of Athens
>> Iroon Politehniou 9
>> 15780 Athens, Greece
>> Phone: (+30) 210 772 4298
>> e-mail: nkontol@central.ntua.gr
>>
>
>
>
> --
> *Joshua Harker
> w: www.joshharker.com
> e: info@joshharker.com
> fb:
> Facebook Artist Page<http://www.facebook.com/pages/Joshua-Harker-Artist/195062218474?ref=sgm>
> *
>
>
-- *Joshua Harker w: www.joshharker.com e: info@joshharker.com fb: Facebook Artist Page<http://www.facebook.com/pages/Joshua-Harker-Artist/195062218474?ref=sgm> *Received on Wed Oct 03 20:18:42 2012
This archive was generated by hypermail 2.1.8 : Fri Mar 29 2013 - 15:24:46 EET