[rp-ml] Comparison of Stratasys FDM Parts Quality Compared to Lower Cost FDM Type Systems

From: Chathamres <chathamres_at_aol.com>
Date: Mon May 07 2012 - 18:42:34 EEST

Has anyone compared the quality of parts made on a newer Stratasys FDM compared to the same part made from any of the lower cost FDM systems (e.g., RepRap)? If so, could you share the results with the list or us?

Doug

Chathamres
chathamres@aol.com
Received on Mon May 07 18:46:19 2012

This message: [ Message body ]
Next message: Olaf Diegel: "RE: [rp-ml] Comparison of Stratasys FDM Parts Quality Compared to Lower Cost FDM Type Systems"
Previous message: Doug Mitchell: "[rp-ml] 3D Printing in Ripley's"
Next in thread: Olaf Diegel: "RE: [rp-ml] Comparison of Stratasys FDM Parts Quality Compared to Lower Cost FDM Type Systems"
Reply: Olaf Diegel: "RE: [rp-ml] Comparison of Stratasys FDM Parts Quality Compared to Lower Cost FDM Type Systems"
Reply: Stewart Dickson: "Re: [rp-ml] Comparison of Stratasys FDM Parts Quality Compared to Lower Cost FDM Type Systems"

Contemporary messages sorted: [ By Date ] [ By Thread ] [ By Subject ] [ By Author ] [ By messages with attachments ]

This archive was generated by hypermail 2.1.8 : Fri Mar 29 2013 - 15:24:46 EET