Does the laser fire using the pickle ?
Does the machine initialize ? (X,Y, Z)
Did you reseat the boards ?
Clean the board contacts ?
Make sure the maintenance key is not in the on position ?
Check the ribbon cable and make sure all the pins are straight and the
ribbon is not skewed on the connector (Very common on the old LOM machines)
Cheers,
e-
From: owner-rp-ml@rapid.lpt.fi [mailto:owner-rp-ml@rapid.lpt.fi] On Behalf
Of Nagy Attila
Sent: Sunday, October 30, 2011 7:56 PM
To: rp-ml@rapid.lpt.fi
Subject: [rp-ml] Helysis LOM 1015
Hi Everyone
I recently purchased an old Helysis LOM 1015 system. It turned out there is
a communication error between the computer and Laser board. I'm not sure if
the board is faulty, or the system is too old, but I want to fix it. Anyone
has an idea where can I get a second laser board, even for troubleshooting
purpose? Any ideas how can I troubleshoot it otherwise?
Thank you
Attila NAGY
Received on Mon Oct 31 21:13:43 2011
This archive was generated by hypermail 2.1.8 : Sat Jan 07 2012 - 13:25:43 EET