Re: [rp-ml] problem with Zprinter

Thank you all for your helpful advices.

I contacted Zcorp service and it seems that the problems comes from the
flash drive which should be replaced.

Regards,

On Wed, Dec 22, 2010 at 9:45 PM, Rim Buntinas <rim@drumagog.com> wrote:

> It sounds to me from the error that the software on your machine's hard
> drive is corrupted. Zcorp can sell you a new hard drive with the software
> preloaded for about $400
>
> Rim
>
>
> On Dec 22, 2010, at 5:43 PM, "The Creature Company" <
> mail@creaturecompany.com> wrote:
>
> It's been my experience that zcentral and zcorp technical service reps are
> very helpful and informative about all errors. Did you try them? They even
> offered me advice with my one test legacy machine.
>
> Lino
>
> On Wed, 22 Dec 2010 09:18:21 -0800, Yaser Shanjani <y.shanjani@gmail.com>
> wrote:
>
> Hello,
>
> Our ZPrinter 310plus does not work properly and keep giving the following
> message when we connect a monitor to the main PC board on the machine:
>
> "Fatal Error KERNEL. 146040: No waithost specified but no application
> present
> Setting run mode to -waithost
> Ready for debugger commands"
>
> I was wondering if anyone can advise us how to deal with this problem.
> Where can we find the debugger commands?
>
> Thanks,
> --
> Yaser Shanjani
>
>
>
>
> --
>
> Lino P. Stavole
>
> The Creature Company
>
> cell: 661.433.5283
>
> <http://www.creaturecompany.com>www.creaturecompany.com
>
> Important:
> This e-mail transmission, including any previous messages or attachments to
> it, is covered by the Electronic Communications Act, 18 U.S.C 2210-2521, is
> confidential and may be legally privileged. This E-mail contains information
> that is private, confidential, or is protected by confidentiality or
> non-disclosure product doctrines, and is intended only for the use of the
> individuals(s) names herein. If you are not the intended recipient, be
> advised that unauthorized use, disclosure, copying, distribution, or the
> taking of any action in reliance on this information is strictly prohibited.
> If you have received this E-mail in error, please immediately notify the
> sender by replying to this E-mail, and delete the original message any
> attachments
> <%22mail@creaturecompany.com%22+%3Cmail@creaturecompany.com%3E>
> mail@creaturecompany.com.
>
>
>
>
>

-- 
Yaser Shanjani
Rapid Prototyping Laboratory
Department of Mechanical and Mechatronics Engineering
University of Waterloo