It's been my experience that zcentral and zcorp technical service reps are
very helpful and informative about all errors. Did you try them? They even
offered me advice with my one test legacy machine.
Lino
On Wed, 22 Dec 2010 09:18:21 -0800, Yaser Shanjani <y.shanjani@gmail.com>
wrote:
> Hello,
>
> Our ZPrinter 310plus does not work properly and keep giving the
> following message when we connect a monitor to the main PC board on the
> machine:
>
> "Fatal Error KERNEL. 146040: No waithost specified but no application
> presentSetting run mode to -waithostReady for debugger commands"
>
> I was wondering if anyone can advise us how to deal with this problem.
> Where can we find the debugger commands?
>
> Thanks,
> --Yaser Shanjani
>
-- Lino P. Stavole The Creature Company cell: 661.433.5283 www.creaturecompany.com Important: This e-mail transmission, including any previous messages or attachments to it, is covered by the Electronic Communications Act, 18 U.S.C 2210-2521, is confidential and may be legally privileged. This E-mail contains information that is private, confidential, or is protected by confidentiality or non-disclosure product doctrines, and is intended only for the use of the individuals(s) names herein. If you are not the intended recipient, be advised that unauthorized use, disclosure, copying, distribution, or the taking of any action in reliance on this information is strictly prohibited. If you have received this E-mail in error, please immediately notify the sender by replying to this E-mail, and delete the original message any attachments mail@creaturecompany.com.Received on Thu Dec 23 01:35:01 2010
This archive was generated by hypermail 2.1.8 : Fri Mar 11 2011 - 05:24:19 EET