Re: [rp-ml] Parts washer needed

Try a washer made by Graymills model TC2420L. These washers are not
Stainless, but 20 inch platform will fit. Very compact washer uses less
solvent to fill.

Gary Mitchell
Acu-Cast Technologies, LLC

Markus Hitter wrote:
>
> Am 16.01.2008 um 16:33 schrieb Lisa Bailey:
>
>> or somewhere else we could look for a parts washer?
>
> You can always fill a bucket of sufficient size with your solvent of
> choice (I'd use Isopropanol), dip the entire part into it for some 5
> minutes, then rinse it with a brush and fresh solvent as you resurface
> the part. This manual approach might be more expensive in the (very)
> long term, but should give you first-class results nonetheless.
>
> Don't forget about venting the work area and a distillery to
> regenerate your solvent.
>
>
> Markus
>
> - - - - - - - - - - - - - - - - - - -
> Dipl. Ing. Markus Hitter
> http://www.jump-ing.de/
>
>
>
>
>
>
>
Received on Thu Jan 17 14:40:28 2008