article is here:
http://www.stratasys.com/uploadedFiles/North_America/Media/WP%
20InvestmentCastingBlake.pdf
On Jan 8, 2008, at 6:29 PM, Bob Olsen wrote:
> Dimensions are ABS only machines, so it doubtful they'd make good burn
> out patterns.
>
> The Stratasys web site doesn't seem to indicate a material that
> would be
> appropriate for an investment cast pattern, but we'll wait to see if
> anyone has been successful Doug.
>
> see:
>
> Download FDM System Material Guide- Graphically represents materials
> availability for each FDM system.
> http://www.stratasys.com/fdm_materials.aspx?id=729
>
> Regards, Bob
>
> -----Original Message-----
> From: owner-rp-ml@rapid.lpt.fi [mailto:owner-rp-ml@rapid.lpt.fi] On
> Behalf Of Doug Johnson
> Sent: Tuesday, January 08, 2008 1:51 PM
> To: 'Rp-ml'
> Subject: [rp-ml] Stratasys models for investment casting
>
> Hey All,
>
> I had a customer ask me about using Dimension Printer models for
> investment casting masters?
>
> Is anyone doing this?
>
> Successfully?
>
> Looking for advice.
>
> Thanks,
>
> Doug Johnson
> GXSC
>
>
>
-- Rod McCormick Professor of Jewelry & Metalsmithing The University of the Arts Crafts Department 320 S. Broad Street Philadelphia, PA 19102 rmccormick@uarts.eduReceived on Wed Jan 09 13:27:56 2008
This archive was generated by hypermail 2.1.8 : Tue Jan 06 2009 - 15:48:27 EET