RE: [rp-ml] New RP Device

From: Marshall Burns (ListMail@fabbers.com)
Date: Wed Dec 12 2007 - 16:00:32 EET

• Next message: Terry Wohlers: "Re: [rp-ml] 3D Printing of Video Game Characters"
• Previous message: Terry Wohlers: "[rp-ml] Fw: 3D Printing of Video Game Characters"
• In reply to: Terry Wohlers: "Re: [rp-ml] New RP Device"
• Next in thread: Terry Wohlers: "Re: [rp-ml] New RP Device"
• Reply: Terry Wohlers: "Re: [rp-ml] New RP Device"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

> The Mcor Matrix machine sells for EUR 18,900. Annual maintance is EUR
1,500.

Hi Terry,

            Thanks for the price point. Not quite home market yet, but if it
uses cheap office paper, that's helpful.

            Can you give the price of the consumables? I suppose that would
mean the blades and adhesive you mentioned in another e-mail. And are there
any requirements on the paper to be used?

            That WSJ article and video were great. The video even had a
little clip of the Genie prototype in it.

Regards,

Marshall

• Next message: Terry Wohlers: "Re: [rp-ml] 3D Printing of Video Game Characters"
• Previous message: Terry Wohlers: "[rp-ml] Fw: 3D Printing of Video Game Characters"
• In reply to: Terry Wohlers: "Re: [rp-ml] New RP Device"
• Next in thread: Terry Wohlers: "Re: [rp-ml] New RP Device"
• Reply: Terry Wohlers: "Re: [rp-ml] New RP Device"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Tue Jan 01 2008 - 18:13:10 EET