[rp-ml] Question on how to clean SLA parts

From: Wehl (m.vries@wehl-partner.com)
Date: Fri Oct 28 2005 - 13:42:05 EEST

• Next message: Wehl: "Re: [rp-ml] Question on how to clean SLA parts"
• Previous message: Andrew Graves: "[rp-ml] Looking for SLA500"
• Next in thread: Wehl: "Re: [rp-ml] Question on how to clean SLA parts"
• Maybe reply: Wehl: "Re: [rp-ml] Question on how to clean SLA parts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello list,

I'd like to ask you all if there is some magical way
to clean the parts just taken out of an SLA machine.
There always seems to stick some semi cured resin
on the support side of the parts, needing some
brushing in a cleaning solvent.
We've been looking into a cleaning machine but
still the results are not 100%.
Would ultrasonic cleaning be a solution?

Thanks for any response!

Lammertus de Vries
Wehl & Partner

• Next message: Wehl: "Re: [rp-ml] Question on how to clean SLA parts"
• Previous message: Andrew Graves: "[rp-ml] Looking for SLA500"
• Next in thread: Wehl: "Re: [rp-ml] Question on how to clean SLA parts"
• Maybe reply: Wehl: "Re: [rp-ml] Question on how to clean SLA parts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Mon Jan 02 2006 - 08:09:22 EET