RE: [rp-ml] Looking for InVision Finisher

From: James McMurray (mcmurray@u.washington.edu)
Date: Fri May 20 2005 - 03:20:59 EEST


Darius, Try using a hair dryer or heat gun and a little compressed air,
place the part on an absorbent towel.

 

Regards,

 

 

---- James McMurray ______________________ mcmurray@u.washington.edu

-----Original Message-----
From: owner-rp-ml@rapid.lpt.fi [mailto:owner-rp-ml@rapid.lpt.fi] On Behalf
Of DarekL
Sent: Thursday, May 19, 2005 2:31 PM
To: rp-ml@rapid.lpt.fi
Subject: [rp-ml] Looking for InVision Finisher

 

I have some poorly cleaned InVision SR parts with layer of support wax still
covering entire surface. Was wondering whether I can find somebody with the
InVision Finisher oven who would be willing to give this part an extra
burning time.. :)

 

Darius Lipinski

Toronto, Canada



This archive was generated by hypermail 2.1.7 : Mon Jan 02 2006 - 08:09:13 EET