Hello Andrew
Our service department could help you. Please contact off the list
service@multistation.com
or monday morning ( your time) + 33 2 9916 35 35
Best regards
Yannick Loisance
www.multistation.com
----- Original Message -----
From: "Andrew Werby" <a.werby@comcast.net>
To: <rp-ml@rapid.lpt.fi>
Sent: Friday, May 14, 2004 9:43 PM
Subject: [rp-ml] Sanders ModelMaker 6
> [I recently got a used Sanders ModelMaker 6 "as is". Unfortunately, as it
> is, it doesn't actually work. It's supposed to wake up and home the X and
Y
> axes, but this doesn't happen. Instead, the software gets as far as
reading
> the temperature inputs, then freezes- one can't enter any data and has to
> quit with a "3-finger salute". I've tried reinstalling the software to no
> avail. I'm not sure if it's a hardware or a software problem, or both. All
> the drives are housed in this antique DOS tower that came with it, but I
> don't have any way to figure out what's going on in there (or not). Does
> anybody out there in RP-land have any idea how to troubleshoot these
> machines? Does anybody actually fix them? Any words of wisdom would be
> welcome (even if the sage advice is to give up and sell it for parts). I
> tried Sanders/Solidscape, but they were less than helpful...]
>
> Andrew Werby
> www.computersculpture.com
>
>
>
>
>
>
>
Received on Sat May 15 13:03:35 2004
This archive was generated by hypermail 2.1.8 : Tue Jan 12 2010 - 19:37:11 EET