From: Steven Adler \( A3DM \) (adler@a3dm.com)
Date: Mon Dec 08 2003 - 19:25:19 EET
tom..&...Al.....
ENVISIONTEC PERFACTORY resin is $225.00 per Kilogram
3D SYSTEMS INVISION ( which is what you are discussing on this thread )
is $200.00 per lb
Steven Adler
Automated 3D Modeling, Inc
www.a3dm.com <http://www.a3dm.com/>
603.433.4369
-----Original Message-----
From: owner-rp-ml@rapid.lpt.fi [mailto:owner-rp-ml@rapid.lpt.fi] On
Behalf Of Tom Richards
Sent: Monday, December 08, 2003 10:23 AM
To: AHastbacka@aol.com
Cc: RP-ML
Subject: Re: Material Cost for the Invision
Whoops, Al, you are right!
I re-ran my calculation, as follows:
$200/lb (Perfactory resin) x 1lb/453.59 gm x 1.1 gm/cc x 16.387 cc/cu
inch = $7.95/cu inch.
----- Original Message -----
From: AHastbacka@aol.com
To: Thoms1991@hotmail.com
Sent: Sunday, December 07, 2003 7:49 PM
Subject: Re: Material Cost for the Invision
Using your density number, I come up with 24 cu inches per pound or
approximately $8 per cubic inch.
Al
This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:18:26 EET