Ztech-STL Software

From: info@ztech3d.com
Date: Fri Oct 24 2003 - 12:51:00 EEST

Next message: Prototipagem Rapida: "LaserForm ST200?"
Previous message: John Kerr: "EOS learned lesson in their own country"
Next in thread: Scott Tilton: "RE: Ztech-STL Software"
Maybe reply: Scott Tilton: "RE: Ztech-STL Software"
Maybe reply: Scott Tilton: "RE: Ztech-STL Software"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

('binary' encoding is not supported, stored as-is)
Ztech Solutions is proud to anounce a new software to view and repair STL files.

To download a free copy go to: http://www.ztech3d.com/Setup_Ztech-STL.zip

Recommended computer system:
Processor: 1GHz or higher
RAM: 128Mb or higher
Graphic card: GeForce3, Radeon 7500 or higher

Ztech Solutions
info@ztech3d.com

Msg sent via iPowerWeb WebMail System - http://www.ipowerweb.com

Next message: Prototipagem Rapida: "LaserForm ST200?"
Previous message: John Kerr: "EOS learned lesson in their own country"
Next in thread: Scott Tilton: "RE: Ztech-STL Software"
Maybe reply: Scott Tilton: "RE: Ztech-STL Software"
Maybe reply: Scott Tilton: "RE: Ztech-STL Software"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:18:15 EET