From: Bathsheba Grossman (sheba@bathsheba.com)
Date: Wed Jan 08 2003 - 03:40:27 EET
On Tue, 7 Jan 2003, Jonathan Chertok wrote:
> I have a drawing that I wish to get into a waterjet or laser cutting machine
> to get an intricate logo cut out of metal.
>
> The original is a linotype (I believe) reproduced on paper, and I also have a
> continuous tone negative photographically shot of this original.
>
> Can someone advise me as to whether there is software that can get me a
> vector-based dxf (or similar) with a complicated logo (shareware?!) and
> whether there is a photo-based etching process that I might look into as
> being cost effective?
You could probably get a laser or waterjet toolpath here:
http://art-to-part.mothtamer.com
-Sheba
-- Bathsheba Grossman phone (831)429-8224, fax (831)460-1242 Sculpting geometry bathsheba.com Solidscape prototyping protoshape.com
This archive was generated by hypermail 2.1.7 : Sat Jan 17 2004 - 15:16:59 EET