RE: *.dxf to *.prt

From: Dan Medford (dmedford@qcinspect.com)
Date: Tue Dec 03 2002 - 22:13:53 EET

• Next message: DAVID albright: "Machining was prototypes"
• Previous message: Dan Medford: "RE: Convertion STL - IGES (surfaces)"
• Maybe in reply to: Dimitris Karigiannis: "*.dxf to *.prt"
• Next in thread: Jeffrey Everett: "Re: Sand Casting of Small Parts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Yes, there are a few ways to translate your DXF files into PRT. Please
give us a call at 800-959-0632...

Sincerely,
Dan Medford - President
QC Inspection Services, Inc.
www.qcinspect.com

-----Original Message-----
From: owner-rp-ml@rapid.lpt.fi [mailto:owner-rp-ml@rapid.lpt.fi]On
Behalf Of Dimitris Karigiannis
Sent: Tuesday, December 03, 2002 3:06 AM
To: rp-ml@rapid.lpt.fi
Subject: *.dxf to *.prt

Hello list

Does anyone know a way to translate *.dxf files to *.prt ?

Thank you for your help.

Dimitris Karigiannis
Department of Mechanical Engineering
University of Patra
Greece
dkar@lms.mech.upatras.gr

• Next message: DAVID albright: "Machining was prototypes"
• Previous message: Dan Medford: "RE: Convertion STL - IGES (surfaces)"
• Maybe in reply to: Dimitris Karigiannis: "*.dxf to *.prt"
• Next in thread: Jeffrey Everett: "Re: Sand Casting of Small Parts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:14:42 EET