STL file conversion

From: williquette.mk@pg.com
Date: Thu May 23 2002 - 20:00:15 EEST

• Next message: Timothy J Gornet: "Re: STL file conversion"
• Previous message: Prahlad Vadakkepat: "Out of Office AutoReply: Comment to us."
• Next in thread: Timothy J Gornet: "Re: STL file conversion"
• Maybe reply: Timothy J Gornet: "Re: STL file conversion"
• Maybe reply: Steve Stewart: "RE: STL file conversion"
• Reply: Ron Barranco: "RE: STL file conversion"
• Maybe reply: Jeroen van den Hout: "Re: STL file conversion"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

List,
Could someone tell me if there is any software or anything else out there that
will convert in STL back into a working CAD drawing? I need to do this so that
i can get precise measurements off of a file that i received from 3D systems.

Thanks
Matt

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

• Next message: Timothy J Gornet: "Re: STL file conversion"
• Previous message: Prahlad Vadakkepat: "Out of Office AutoReply: Comment to us."
• Next in thread: Timothy J Gornet: "Re: STL file conversion"
• Maybe reply: Timothy J Gornet: "Re: STL file conversion"
• Maybe reply: Steve Stewart: "RE: STL file conversion"
• Reply: Ron Barranco: "RE: STL file conversion"
• Maybe reply: Jeroen van den Hout: "Re: STL file conversion"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:49 EET