Re: Needed information

From: Michael Tsenter (nesttech@pacbell.net)
Date: Fri Feb 08 2002 - 18:46:49 EET

• Next message: Giorgos Hatzilias: "RE: Parting line calculation and Undercut: Paraform DFM Solution"
• Previous message: Jelena Stojadinovic: "Needed information"
• In reply to: Jelena Stojadinovic: "Needed information"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

You can contact CAMATTINI, SpA in Italy.

Contact: Eugenio Dall'Argine, tel: +39-0521-304711
e-mail: eugenio.dallargine@camattini.it
web page: http://www.camattini.it

Best regards,
Michael Tsenter

Jelena Stojadinovic wrote:

> Dear Sir, We are interested in epoxy resins for making tools for
> thermic formating up to 250 degrees celsius. Can you suggest us what
> type of product is the best, what are the prices and where we can by
> it. We are situated in Serbia, Yugoslavia. Is there any branch office
> near our place where we can by it. Olja
> KamatovicPolyagramPetrovac34000 KragujevacYugoslavia

--
NEST Technologies, Inc.
3849 Ridgemoor Drive
Studio City, CA 91604 USA
Tel: 818-761-6500
Fax: 818-761-6116
e-mail:  nesttech@pacbell.net
web site:  http://www.nesttechnologies.com
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

• Next message: Giorgos Hatzilias: "RE: Parting line calculation and Undercut: Paraform DFM Solution"
• Previous message: Jelena Stojadinovic: "Needed information"
• In reply to: Jelena Stojadinovic: "Needed information"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:27 EET