Re: TAFA - Low temp melt metal

From: thoms1991 (thoms1991@hotmail.com)
Date: Fri Jan 11 2002 - 18:59:49 EET

• Next message: Rafael Santillan: "Re: Scanner for jewelry"
• Previous message: Rupert Soar: "suscribe"
• In reply to: Brad Fox: "TAFA - Low temp melt metal"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Brad: I've used propane torch applied flux and silver solder (hardware store) followed by remachining.
  ----- Original Message -----
  From: Brad Fox
  To: rp-ml@rapid.lpt.fi
  Sent: Thursday, January 10, 2002 11:29 AM
  Subject: TAFA - Low temp melt metal

  List:
  I'm looking for the material - I thought - was once marketed by TAFA. I'm looking for a metal that can be melted or almost "brazed" onto an existing steel insert. It's down into a tight area that can not be welded.

  Thanks!

  Brad

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

• Next message: Rafael Santillan: "Re: Scanner for jewelry"
• Previous message: Rupert Soar: "suscribe"
• In reply to: Brad Fox: "TAFA - Low temp melt metal"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 21 2003 - 20:13:20 EET