Re: Milling machine question

From: Designxy@aol.com
Date: Tue Nov 27 2001 - 18:56:59 EET

Next message: EdGrenda@aol.com: "Here we go again...Virus warning"
Previous message: Carl Dekker: "Remove : Get Rid of Call Reluctance!"
Maybe in reply to: Rob Holmes: "Milling machine question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

MaxNC 10 is little toy with no ability to reproduce any thing better than
0.02"
exactness. Is good only for wax or similar material. And is not stable
electronically.
Will skip some paths here and there.
Kaz Boroszko
annfortune@aol.com

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

Next message: EdGrenda@aol.com: "Here we go again...Virus warning"
Previous message: Carl Dekker: "Remove : Get Rid of Call Reluctance!"
Maybe in reply to: Rob Holmes: "Milling machine question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:58:08 EET