Magics software by Materialise, in the later revisions does a good job of
extruding or cutting in lettering.
http://www.materialise.com/
Doug Groh
PGK Engineering
248-577-5227
Dale Rosema wrote:
> I am looking for a way to have lettering done to put on a sample
> prototype part. Are there any software programs for "extruding" logos
> and lettering? Thanks in advance.
> Dale Rosema
> IHS Prototyping
>
> For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:58:01 EET