PTFE injection moulding - East Midlands UK any ideas

• Next message: Elaine Hunt: "Fwd: RE: benchmarking of RP systems"
• Previous message: Martin Steyn: "(no subject)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear all

I am wrestling with a manufacturing challenge at the moment: I would like to produce moulded components for a precision medical flow meter in PTFE. However, no sooner do i mention PTFE then conventional moulders go into apoplexy. Does anyone know or could suggest a UK based moulder capable of small batch PTFE injection mouling. Alternatively, other forums or hyperlinks would be greatly appreciated.

Dr Phil Reeves
Chief Executive
Engineering Forum
The Engine
Derby Road, Mansfield
Nottinghamshire
NG18 5FE

01623 658666
01623 658333
phil@engineeringforum.co.uk

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

• Next message: Elaine Hunt: "Fwd: RE: benchmarking of RP systems"
• Previous message: Martin Steyn: "(no subject)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:45 EET