Re:

From: Panagiotis Moustakas (pmoust@lms.mech.upatras.gr)
Date: Mon Jul 23 2001 - 10:24:18 EEST


Have you checked the plotter's push-button on the back side of machine, over
the general and heater switches? This message appears when then button is
off. I hope this helps.

  Panagiotis Moustakas
  Research assistant
  Lab for Manufacturing Systems
  Director: Prof. G.Chryssolouris
  Department of Mechanical Engineering & Aeronautics
  University of Patras
  Rio 261 10
  Patras
  Greece
  Fax: + 3 061 997744
  Work: + 3 061 997264

reza moini wrote:

> Dear Sir
> I have a LOM machinefrom Helisys (LOM1015) but when I
> start it,this error message will appear: "can not
> connect XY plotter"
> How can I solve this problem?
> Thank you
> REZA MOINI
>
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/
>
> For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/

For more information about the rp-ml, see http://rapid.lpt.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:57:33 EET