Sorry, I should have provided their site in first place.
www.magmasoft.com
Rick
asrp@ozemail.com.au
----- Original Message -----
From: Yasser Hosni
To: asrp@ozemail.com.au
Sent: Monday, March 12, 2001 1:19 PM
Subject: Re: Best solidification software?
Rick:
Could you provide more information on MagmaSoft (We site, ..etc.).
Thx.
YH
Yasser Hosni, Ph.D., PE.
Professor of Engineering
Industrial Engineering and Management Systems
University of Central Florida
4000 Central Florida Blvd.
Orlando, FL 32816
Tel (407) 823-5817
Fax (407) 823-3413
E-mail: yhosni@mail.ucf.edu
>>> "asrp" <asrp@ozemail.com.au> 02/14/01 05:33AM >>>
Like Jim mentioned it depends upon which material you want to use
for solidification. We use MagmaSoft for simulation, which gave us an
impressive improvement in our Al. diecasting process. Pl. contact me if you
need any further info.
Rick
asrp@ozemail.com.au
----- Original Message -----
From: "Vadim Pikhovich" <VPikhovich@oshtruck.com>
To: <rp-ml@bart.lpt.fi>
Sent: Wednesday, February 14, 2001 8:18 AM
Subject: Best solidification software?
> Hello,
>
> I would like to find out what programs are best for solidification
> modeling. I am also interested in companies that use them to see whether
it
> would be possible to use their service to run a few parts.
>
> Thanks in advance,
>
> Vadim Pikhovich
> phone (920) 235 9151 ext. 5305
>
>
>
>
> ______________________________________________________________________
> The information contained in this electronic mail message is confidential
> information and intended only for the use of the individual or entity
named
> above, and may be privileged. If the reader of this messages is not the
> intended recipient, you are hereby notified that any dissemination,
> distribution or copying of this communication is strictly prohibited. If
> you have received this transmission in error, please contact the sender
> immediately, delete this material from your computer and destroy all
> related paper media. Please note that the documents transmitted are not
> intended to be binding until a hard copy has been manually signed by all
> parties.
> Thank you.
>
>
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:56:57 EET