Hello,
Can any of you provide contacts for vapor depositing urethane? We have a
customer that would like to create an RF shield on their prototypes and we
believe that vapor deposition would be the best route. As an alternative,
has anyone had success using "filled urethanes" to create conductive
castings? We have tried using carbon black on several occasions with mixed
results. Typically, the amount of carbon black required to achieve any
conductivity is so high that the urethane/carbon mixture becomes a thick
sludge and will not flow into the molds.
Thanks for your help,
Bruce E. LeMaster
Applied Rapid Technologies Corporation
265 Cambridge Street, Suite 100
Fredericksburg, Virginia 22405
(540)371-1100 / (540)371-4100 fax
http://www.artcorp.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:56:47 EET