RE: Lightyear supports

• Next message: Rafael Santillan: "software to convert point cloud to STL"
• Previous message: Umang Jain: "Student looking for info about STL format/slice programming in C++"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

        Since Bra Van Dike mentioned about the minimum support angle, I believe
its true because my minimum support angle is at 26 and it has been creating
a lot of unnecessary supports that I have to spend tremendous amount of
time editing each support prior to slicing any part. I also use
Bridgeworks just to expedite my slicing.

Prince Ladu
Arrk Product Development Group
8880 Recho Road
San Diego, Ca 92126
(858)626-2308
ladu@arrk.com

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: Rafael Santillan: "software to convert point cloud to STL"
• Previous message: Umang Jain: "Student looking for info about STL format/slice programming in C++"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Fri Jan 04 2002 - 09:56:45 EET