Output of FEA/CFD meshes to CAD

From: Chris Sutcliffe (c.j.sutcliffe@liverpool.ac.uk)
Date: Sun Jul 09 2000 - 18:26:35 EEST

Next message: lafont: "RP in Spain"
Previous message: D. Talbot (Scicon Tech): "since its friday..."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

test StationeryDear List,

Has anyone output an FEA/CFD mesh to CAD and then built it in RP. If so
could you pass on details of the steps involved.

Thanks in advance

Chris

Dr. Chris Sutcliffe
Rapid and Micro Manufacturing Research
The University of Liverpool
Department of Engineering
Ashton Building
Brownlow Hill
Liverpool
L69 3GL

Tel. (0151) 794 4316
Fax. (0151) 794 4675
Email c.j.sutcliffe@liv.ac.uk

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: lafont: "RP in Spain"
Previous message: D. Talbot (Scicon Tech): "since its friday..."
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:47 EEST