Re: AppleMac -> STL?

From: Adrian Rudin (a.rudin@fhbb.ch)
Date: Mon May 29 2000 - 15:04:25 EEST

Next message: Delft Spline Systems: "Re: AppleMac -> STL?"
Previous message: Bill Bedford: "Re: AppleMac -> STL?"
In reply to: Matthijs Siljee: "AppleMac -> STL?"
Next in thread: Delft Spline Systems: "Re: AppleMac -> STL?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear Matthijs

I have the same expirience as Bill Bedford.
STLs created from FormZ are well done.

Best regards
Adrian Rudin

At 17:20 29.05.2000 +1200, Matthijs Siljee wrote:
>Greetings.
>
>At our School of Design we have AppleMacs with Vellum Solids and FormZ
>as CAD software. Does anyone have experience with generating /
>translating into STL files in a Mac environment ?
>
>Thanks.
>
>Matthijs Siljee lecturer
>Massey University School of Design
>Private Box 756
>Wellington - New Zealand
>ph +64 - (0)4 - 384 3846 ext 227
>email M.N.Siljee@massey.ac.nz
>
>
>For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Delft Spline Systems: "Re: AppleMac -> STL?"
Previous message: Bill Bedford: "Re: AppleMac -> STL?"
In reply to: Matthijs Siljee: "AppleMac -> STL?"
Next in thread: Delft Spline Systems: "Re: AppleMac -> STL?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:35 EEST