small diameter milling cutters

From: Chris Sutcliffe (c.j.sutcliffe@liverpool.ac.uk)
Date: Tue Apr 18 2000 - 11:43:45 EEST

Next message: Joseph P. Frantz: "Mail X2"
Previous message: eschl: "[Fwd: HERE'S YOUR INSIDER FOR 4-17-00]"
Next in thread: Greg Pettengill: "Re: small diameter milling cutters"
Reply: Greg Pettengill: "Re: small diameter milling cutters"
Reply: Delft Spline Systems: "Re: small diameter milling cutters"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dear List

A little while ago maybe up to 12 months I put a request on the list for info on companies who produce small diameter milling cutters. One of our number was kind enough to reply with the names of two companies unfortunately however I have lost (put in a safe place and forgotten where the safe place is) the info so can whoever sent the original info send it again.

Thanks in advance

Chris

Dr. Chris. Sutcliffe
Rapid Prototyping and Micromanufacture Research
Department of Engineering
3 Brownlow St.
Liverpool L69 3GL

(0151) 794 8022 Direct
(0151) 794 7729 Mobile
(0151) 794 8021 Secretary

EMail c.j.sutcliffe@liv.ac.uk

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Joseph P. Frantz: "Mail X2"
Previous message: eschl: "[Fwd: HERE'S YOUR INSIDER FOR 4-17-00]"
Next in thread: Greg Pettengill: "Re: small diameter milling cutters"
Reply: Greg Pettengill: "Re: small diameter milling cutters"
Reply: Delft Spline Systems: "Re: small diameter milling cutters"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:18 EEST