Over the past weekend I had a power outage while building parts on our
SLA. Monday morning, the machine was off, with the zephyr bar sitting idle in
the middle. It took a good 3 hours for the laser to get back to normal after
the abrupt shut down, and I had to redefine where the lasers hit the sensors.
I was wondering if anybody knew of a good backup power supply for the
SLA when the power goes out or surges.
Thanks,
-- Keith D. Wheadon Rapid Prototyping Manager Solid Design & Analysis Ph (801)328-8220 www.sdaa.com email: keith.wheadon@sdaa.comFor more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 23:03:14 EEST