Dear list,
It is possible to apply a texture to stereolithography (and other)
models. We work with Lee Eisinger of Akron Metal Etching to achieve ANY
texture that is desired. Lee has the ability to apply a texture the
same as it would be on the production tooling. By applying the texture
to the SL pattern you can then make silicone molds and cast the texture
into each urethane part.
There were several postings to the rp-ml back in March if you would like
to go back to the archives and read the messages. You can also contact
Lee at the following:
Lee Eisinger - President
Akron Metal Etching Co.
463 Locust Street
Akron, Ohio 44307
(330) 762-7687 phone
(330) 762-7686 fax
www.textureame.com
Regards,
Bruce E. LeMaster
-- Applied Rapid Technologies Corporation 265 Cambridge Street, Suite 100 Fredericksburg, Virginia 22405 (540) 371-1100 / (540) 371-4100 fax http://www.artcorp.comFor more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:53:32 EEST