In a message dated 99-09-17 15:39:29 EDT, calexander@solidconcepts.com writes:
<< I can't directly answer your question about auto Z correction. >>
There is of course a Lightyear workaround for auto Z correct if the wrong Ec
Dp are specified. You can specify none or some number of down facing layers
to be shifted upwards. A crude approach at best. The Z correction in
Solidview where you can dial in the amount of upward shift for up to 16
different ranges based on the angle of the down facing surface is more likely
to give you accurate geometry. But you will have to run some test parts to
get the best results.
Andy Scott
Lockheed Martin Aero Sys
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:47 EEST