Hi Mr. Sunil,
We've tried out Compunix's IGES-STL converter and it's pretty good. You can
try the software by downloading it from: http://www.compunix-usa.com
We're also happy with Brock-Rooney's IGS-STL converter. However, i've
forgotten their website, so you might have to perform a search for it.
Hope this helps.
BRgds,
Raymond Tan,
Rapid Prototyping and Manufacturing Center,
Research & Development Department,
PROTON BHD.
Shah Alam, Malaysia.
Ph: 603-5111055 ext.2542
Fax: 603-5152380
http://www.proton.com/rapid/main.htm
> -----Original Message-----
> From: Sunil Yadav [mailto:syadav@FNAL.Gov]
> Sent: Tuesday, August 17, 1999 7:15 AM
> To: rp-ml@ltk.hut.fi
> Subject: Shareware for making STL file from iges files
>
>
> Hi everyone,
>
> I am looking for a shareware to make STL file from iges
> files. I have IDEAS
> master series 6.0 for making solid models. I can use "export
> as STL" in
> IDEAS (with tolerance of 0.01 mm) to make STL file. However, I am not
> satisfied with the STL file when I use a viewer to view it. The
> triangulation of the surface appears slightly coarse. I can
> not reduce the
> tolerance further from 0.01 mm since the part was made with 0.01 mm
> tolerance. Is there a shareware available which I can use to
> make STL file
> from my iges models. Also, is there a way to check the
> accuracy of surface
> representation of the STL file. Any help would be greatly appreciated.
>
> Thanks,
> Sunil
> syadav@fnal.gov
============================================================
Disclaimer Note:
"This email and any files transmitted with it are confidential and intended
solely for the use of the individual or entity to whom they are addressed.
This communication may contain material protected by intellectual property
rights laws. If you are not the intended recipient or the person responsible
for delivering the email to the intended recipient, be advised that you have
received this email in error and that any use, dissemination, forwarding,
printing, or copying of this email is strictly prohibited. If you have
received this email in error please notify the System Administrator at
administrator@proton.com.my "
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:22 EEST