Dear RPers,
We are preparing a request for quote to go out to a number of
fabrication sources that can do thin-walled structures. We would like to
also submit the RfQ to a couple of sources that do EDM or water-jet cutting.
Do any of you have recommendations of good sources for these services?
Thank you for your assistance.
Best regards,
Marshall Burns
Marshall@Ennex.com
Ennex Corporation, Los Angeles, USA, (310) 824-8700
www.Ennex.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:52:11 EEST