Re: High speed machining from STL's

From: Oneillcf@aol.com
Date: Thu May 13 1999 - 05:37:10 EEST

Next message: Giorgos Hatzilias: "RE: High speed machining from STL's"
Previous message: Terry T. Wohlers: "High speed machining from STL's"
Maybe in reply to: Terry T. Wohlers: "High speed machining from STL's"
Next in thread: Ed Lambourne: "RE: High speed machining from STL's"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

PowerMill from Delcam is available. It's a little more than $10K. I saw a
very impressive demo on the .stl file of my choice. If you are serious I
would recommend that you do the same.

Chris O'Neill
Pratt & Whitney

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Giorgos Hatzilias: "RE: High speed machining from STL's"
Previous message: Terry T. Wohlers: "High speed machining from STL's"
Maybe in reply to: Terry T. Wohlers: "High speed machining from STL's"
Next in thread: Ed Lambourne: "RE: High speed machining from STL's"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:42 EEST