rapid tooling materials

From: will pattison (wpattison@4ddesign.com)
Date: Thu May 06 1999 - 18:14:43 EEST

Next message: razdan: "RE: state of art on reverse engineering"
Previous message: Dauri Grellmann: "BURNOUT OF QUICKCAST PATTERNS"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

ok, i've done lots of research, now i want to hear any personal
experiences, either here or off-line. has anybody out there used either
polysteel, redtool, or prototool? what kind of parts did you run? what
material? how many shots? cost of tool? time to build it? i need any
specifics that aren't top secret.

thanks in advance...

will pattison
product development engineer
4d design, inc.
austin, texas

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: razdan: "RE: state of art on reverse engineering"
Previous message: Dauri Grellmann: "BURNOUT OF QUICKCAST PATTERNS"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:39 EEST