C-Mold

From: DANIEL CHARLES DAVIS (DANIEL@proton.com.my)
Date: Wed Apr 21 1999 - 10:59:28 EEST

Next message: DANIEL CHARLES DAVIS: "RE: C-Mold Quickfill"
Previous message: Mnr. D de Beer: "(Fwd) GARPA Newsletter"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello all,

Is anyone out there using C-mold with RIM or castable urethanes? If so,
can you share some generic information regarding the custom resin
specification needed for setting up the C-Mold program? TQ.

--- Regards, Dan Davis PROTON Rapid Prototyping & Manufacturing Center Hicom Industrial Estate, Batu Tiga, PO Box 7100 Shah Alam, 40918 Selangor MALAYSIA +60 3 515-2380 phone/fax http://www.protoncar.com/rapid/index.htm

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: DANIEL CHARLES DAVIS: "RE: C-Mold Quickfill"
Previous message: Mnr. D de Beer: "(Fwd) GARPA Newsletter"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:31 EEST