Hello Ola,
Quite possibly my comapny can assist your requirements. We have an
excellent source for blowmolding prototype volumes. Depending on the
size and complexity we've produced molds by machining and cast aluminum.
Also for consideration is the SLS RapidSteel process. Again the
decision to use either process would come after evaluating available
data, part complexity, part size, delivery constraints and budgets.
We also have a rather unique process where we simulate blow molded parts
by a prototype rotational molding process. For this process we use
rubber molds. Good solution if rapid prototypes is your primary
objective.
Regards,
Jim Williams, President and CEO
Paramount Industries
Rapid Product Development & Manufacturing Specialists
2475 Big Oak Road
Langhorne, PA 19047
215.757.9611 voice x229
215.757.9784 fax
800.RPTOOLS toll free
www.paramountind.com * watch for new page May '99
sales@paramountind.com * request company sales information
ftp.paramountind.com * digital data transfer
-----Original Message-----
From: olah [mailto:olah@ns1.cul.net]
Sent: Sunday, March 28, 1999 10:06 PM
To: rp-ml@bart.lpt.fi
Subject: Blowmolding
Dear List,
We are looking for someone that can make a rapid tool for blowmolding
and
also produce some parts for one of our customer. So far we haven't been
able to find anyone that are doing rapid tooling for this kind of work,
so
if any of you out there are interested or know of anyone that would be,
please contact us by phone, fax or email.
Thank you,
Ola Harrysson
RP-Tech. Inc.
10847 Glen Cove Circle # 208
Orlando, FL 32817
Phone: (407) 672-0011
Fax: (407) 672-0320
email: rptech@cul.net
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:22 EEST