Re: SLC file ?

From: Wayne L Foss (wlfoss@crnotes.collins.rockwell.com)
Date: Tue Feb 23 1999 - 17:19:21 EET

Next message: Caporusso Pier VIto: "Informations on 2D standards for RP"
Previous message: b.Kooijmans@ind.tno.nl: "please subscibe me to the mailinglist"
Maybe in reply to: Florent Salako: "SLC file ?"
Next in thread: A.D.Bhatt: "Re: SLC file ?"
Reply: A.D.Bhatt: "Re: SLC file ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

An .slc file is the slice file for the Stratasys FDM process. I'm not sure,
but I think it only works in Stratasys Quickslice software. It describes
the part and supports profile at each slice. The toolpath for material
extrusion is described by an .sml file.

Wayne Foss
Rockwell Collins
Cedar Rapids, Iowa

Florent Salako <salako@meca.polymtl.ca> on 02/18/99 01:10:34 PM

To: rp-ml@bart.lpt.fi
cc:
Subject: SLC file ?

Does anyone know what a slc file is (in RP) ?
Can I get a file example ?

Thanks.
Florent.

_________________________________________
Florent Salako
Prototech Centre

             Tel: (514) 340-3245-6
             Fax: (514) 340-3246
             salako@meca.polymtl.ca
             http://www.prototech.polymtl.ca/

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Caporusso Pier VIto: "Informations on 2D standards for RP"
Previous message: b.Kooijmans@ind.tno.nl: "please subscibe me to the mailinglist"
Maybe in reply to: Florent Salako: "SLC file ?"
Next in thread: A.D.Bhatt: "Re: SLC file ?"
Reply: A.D.Bhatt: "Re: SLC file ?"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:51:02 EEST