Why are we getting all your email?
Hope this helps. Call me at 317-585-3091 if you would like to discuss it in
more
detail.
>* Part build quality & repeatability?
--- Part quality is acceptable for the speed and intended function of the
machine and
repeatability is very good.
>* Software - user friendliness, etc.?
--- The software is extreamly easy to use. Takes about an hour to learn every
command.
>* How sensitive is the s/w to poor STL files (e.g., SLA = very,
>LOM = minimal)?
--- The software will read bad files as well as good files at about the
same speed.
But bad file make bad parts just like some other technologies.
>* Service?
--- Very good
>* Machine downtime?
--- Minimal.... All machines have their problems, but how the manufacture
deals with
you and the problems you may encounter is what sets these guys apart. They
do a vary
good job. We have had our machine since July of 1997 and only recently have
we seen
the machine go down for more then a few hours for minor repairs .
Vern Carter, CTS
www.3dresource.com
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:50:51 EEST