Vacuum Forming

From: Michael Maurice (mauricem@FS1.QUADRUM.COM)
Date: Tue Jan 12 1999 - 16:16:40 EET

Next message: Jim Rollins: "RE: Plynetics Express' Web site"
Previous message: Wade Williams: "Re: epoxy properties"
In reply to: Ron Clemons: "SLA Bureaus - Somos 8100"
Next in thread: E.M. Groenewolt: "Re: Vacuum Forming"
Reply: E.M. Groenewolt: "Re: Vacuum Forming"
Maybe reply: Foamcaster@aol.com: "Re: Vacuum Forming"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I would like to create parts that can be used for vacuum forming from a soft tool. Is
there a material out there that can be poured and then cures to a state that is ideal for
vacuum forming?

Thank You

Michael Maurice
Quadrum Telecom
Phone: (256) 650-2672
Fax: (256) 650-2699

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

Next message: Jim Rollins: "RE: Plynetics Express' Web site"
Previous message: Wade Williams: "Re: epoxy properties"
In reply to: Ron Clemons: "SLA Bureaus - Somos 8100"
Next in thread: E.M. Groenewolt: "Re: Vacuum Forming"
Reply: E.M. Groenewolt: "Re: Vacuum Forming"
Maybe reply: Foamcaster@aol.com: "Re: Vacuum Forming"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:50:45 EEST