Dear ALL :
I think there might be some alternatives for all the rapid tooling
methods that have already reached their critical point.
When it comes to accuracy(the 1st priority of production mold),
all the rapid tooling methods developed so far could't go over
the conventional CNC tooling.
For turnaround time too, high speed machining technologies have
much more possibilty than rapid tooling methods.
For Invetment Cost, high speed machining technologies can give
us much more possibilty than rapid tooling methods.
So I think there is no alternative of rapid tooling tech. except CNC
HIGH SPEED MACHINING for the time being.
Is there anyone who has some opinions on this ?
Any opinion you can give me would be greatly appreciated...
Best Regards.
Chang-Shik,Min
Precision Technology Center,LG-PRC / LG Electronics Inc.
19-1,Cheongho-Ri,Jinwuy-Myon,Pyungtaek(451-713), R.O.Korea
(Voice)+82-333-660-7090
(Fax)+82-333-660-7384
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:46 EEST