Cheong Toh Kim Alvin wrote:
> Since 2 weeks ago, we started getting parts out from the SLA500 with
> undesirable results unseen before.
>
> >From the look of the part, it sure looks like after certain height of
> building, there was a shift of about 2mm in the X direction & this off-set
> position remained over the next 5mm build before it returned back to the
> original position.
Does mentioned shift depend from geometry of part, or it happens only for one
type of parts you made?
___________________________________________________
With best regards
Artem Yakovlev, Russia
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:20 EEST