Re: SDM

From: Jianpeng Dong (jdong@leland.Stanford.EDU)
Date: Wed Oct 28 1998 - 18:59:57 EET


You can visit our website of Rapid Prototyping Lab at Stanford.

http://www-rpl.stanford.edu

Hope you will enjoy,

Jianpeng

On Wed, 28 Oct 1998, Mr. Tushar R. Mahale wrote:

> RP world,
> Some days back, I came across a site (www.nnun.org) where they had
> mentioned about the capablity of the SDM to handle feautres of size 100
> nanometres. The site did not give any further details regarding this and
> it was quite difficult to understand the methods that had been used to
> achieve such details considering the fact that SDM involves addition of
> material which is later milled out using 5-axsis milling.
>
> I had read a paper tittled " Laser Deposition of Metals for SDM"
> in one of the SFF proceedings by Prof. F.B. Prinz et al....but this
> approach too didnot clarify my doubts, as in this case, metal powder is
> melted by means of a laser which is then followed by the material removal
> process using 5-axsis milling.
>
> I would be obliged if someone could send me some information
> regarding the same.
>
>
> With Regards
>
> Tushar
>
> _______________________________________________________________________________
>
> Tushar Mahale
> Research Engineer Tel: 091-22-578 2545 extn:7832
> Rapid Prototyping Cell Fax: 091-22-576 7803
> Indian Institute of Technology-Bombay
> _______________________________________________________________________________
>
>
>
>
> For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
>

\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_
 \_ Jianpeng Dong Phone: 650-723-1138(office) \_
  \_ Research Assistant 650-725-2031(lab.) \_
   \_ Rapid Prototyping Lab. email:jdong@stanford.edu \_
    \_ Mechanical Engineering Dept. WebSite:rpl.stanford.edu \_
     \_ Stanford University, CA94305 \_
      \_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/



This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:47:02 EEST