Small, Thin-walled Mag Protos

• Next message: Elaine Hunt: "The growth and decline of RP&M events: User comments as organized by me"
• Previous message: Roald Karlsen: "Scanning information"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello RP-ML,

Does anyone know of a good rapid proto house that will Quickcast and/or
machine a few protos in magnesium?

We are looking at relatively complex, small size, thin-walled (1mm), low
clean-up, low quantity parts (12 or so). They are typical cell phone
type parts and we need rapid turn-around (less than 4 weeks).

Please send replys to Eric Phillips:

mailto:eric.phillips@ericsson.com

Eric or myself will forward the results if requested.

Thanks,

Sean Ryan
Cellular R&D
Ericsson Inc.
RTP, NC USA

For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/

• Next message: Elaine Hunt: "The growth and decline of RP&M events: User comments as organized by me"
• Previous message: Roald Karlsen: "Scanning information"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:42 EEST