In a message dated 98-07-24 01:50:48 EDT, mark-s@inav.net writes:
<< Remember when using fast urethanes the heat and pressure of the cure will
effect the dimensional outcome of the part. Cure the mold at the
temperature of the exotherming resin and at the appropriate pressure. If
you are chasing + or - .002 tolerances like most of us. >>
I understand that the mold will expand with temperature as well. So there is
an optimum temperature that will yield the correct dimensions. Might take you
a few test tries to find it though.
Andy Scott LMCO
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:19 EEST