I have just installed a SLA5000 and I am starting to run parts through
it. (Boy that is pretty obvious). The last two nights the sweep stalled
on the fill layer a top surface. It seems that the surface did not
adhere to the bottom layers which allowed for separation of layers. It
also does not happen to all the parts being built. Is this a setup
adjustment or do I have to be aware of some condition and compensate for
it?
Thank
For more information about the rp-ml, see http://ltk.hut.fi/rp-ml/
This archive was generated by hypermail 2.1.2 : Tue Jun 05 2001 - 22:46:10 EEST